Thingiverse
Tool Holder Wall Mount (can print brim)
14
Downloads
17
Likes
0
Makes
This is a wall mount tool holder. Good for pliers, screw drivers, or other tools.
There are other good tool holders out there, but they tend to barely fit a 220x220 build plate only if you position the part perfectly diagonal and leaves no room to print a brim with it. If you print in ABS, or anything but PLA, it's difficult to get a part with a relatively small footprint to stick to the bed without a brim.
I made this part 228mm long instead of the nearly 250mm long the parts that barely
There are other good tool holders out there, but they tend to barely fit a 220x220 build plate only if you position the part perfectly diagonal and leaves no room to print a brim with it. If you print in ABS, or anything but PLA, it's difficult to get a part with a relatively small footprint to stick to the bed without a brim.
I made this part 228mm long instead of the nearly 250mm long the parts that barely
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in