Thingiverse
Z18 Tool Holder
by krandon
1
Downloads
3
Likes
0
Makes
NOTE: Initial print using Simplify3D was too tight of a fit. Tailored the .skp and will try again on MakerBot Print.
Basic bracket to hold needle nose pliers on the side of the MakerBot Z18. 20mm opening should accommodate a variety of handheld tools.
I cut holes in the long face to hopefully save filament. Not sure if it was much better than leaving it flat faced with 10% infill.
Basic bracket to hold needle nose pliers on the side of the MakerBot Z18. 20mm opening should accommodate a variety of handheld tools.
I cut holes in the long face to hopefully save filament. Not sure if it was much better than leaving it flat faced with 10% infill.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in