Thingiverse
Rear Bumper FJ40 Lexan 1:10 scale
by Flachkugel
15
Downloads
7
Likes
0
Makes
A Rear Bumper for the 1_10 Lexan Body FJ40.
You have to put it over the edge of the body, and stick it with a flexible glue. Only a small glue point is enough.
The bumper is adapted to my body. If you cut your body differently, the bumper may not fit so well. I can not guarantee that it fits your body exactly.
For the taillights I left an opening of 5mm. So it should fit 5mm LED. LED is not tested by me
You have to put it over the edge of the body, and stick it with a flexible glue. Only a small glue point is enough.
The bumper is adapted to my body. If you cut your body differently, the bumper may not fit so well. I can not guarantee that it fits your body exactly.
For the taillights I left an opening of 5mm. So it should fit 5mm LED. LED is not tested by me
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in