Thingiverse
Ender 3 MKS Gen v1.4 Case
by TohtoriKuka
66
Downloads
37
Likes
1
Makes
This is a remix from https://www.thingiverse.com/thing:3048856 to fit MKS Gen v1.4 board inside the case.
The case is 33mm longer than then original made by petrzmax, which is the difference between MKS Gen L v1.0 and MKS Gen v1.4 boards. The width of the boards is the same, so there have been no changes to that. I also adjusted the side so it can still be attached to same location as the original case.
I have printed this, but I don't have my board yet, but did measure things with caliber
The case is 33mm longer than then original made by petrzmax, which is the difference between MKS Gen L v1.0 and MKS Gen v1.4 boards. The width of the boards is the same, so there have been no changes to that. I also adjusted the side so it can still be attached to same location as the original case.
I have printed this, but I don't have my board yet, but did measure things with caliber
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in