Titan Aero for Anycubic Chiron (Bowden to Direct Drive)

Ok, here is my remake.

This will work with the original Titan Aero by E3D, probably clones too.
Link: https://e3d-online.com/titan-aero-builder

I´m not very happy with my fan duct, so please re-design it if you wish, the original from Anycubic is too small and far away.

You only need to extend the End-stop cable and the stepper motor cable. (maybe the auto-level cable as well)
As seen on my "overview" picture I disconnected the filament sensor and put it above the printer, together wi