Thingiverse
LED Diffuser Lens for Panel Mounting
by reactron
15
Downloads
18
Likes
1
Makes
LED bezel will mount into a ~12mm hole. Diffuser is to be printed using a translucent plastic. LED is either press-fit or glued in place.
Update: added second versions to provide a bit more tolerance (slop). Try printing one of each and see which set works best for you.
Pro Tip - if you find that the fit between the 2 parts is too tight, just increase the X and Y size of the nut in your slicer to be slightly larger ( somewhere around 106 percent should do the trick ).
Update: added second versions to provide a bit more tolerance (slop). Try printing one of each and see which set works best for you.
Pro Tip - if you find that the fit between the 2 parts is too tight, just increase the X and Y size of the nut in your slicer to be slightly larger ( somewhere around 106 percent should do the trick ).
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in