Thingiverse
Ender 3 short print spool holder
by Barteky
28
Downloads
16
Likes
0
Makes
Customizable spool holder for Creality Ender 3.
You can use it with big (up to 10 cm thick) and small spools.
You need to print every part twice.
If you print part2 v2 you are going to need 4 screws M4 x 10mm and 4 nuts (M3 x 10mm will work as well)
For this holder you need 4 bearings Z809. You can try print bearing i created but i haven't testet it yet.
You can use it with big (up to 10 cm thick) and small spools.
You need to print every part twice.
If you print part2 v2 you are going to need 4 screws M4 x 10mm and 4 nuts (M3 x 10mm will work as well)
For this holder you need 4 bearings Z809. You can try print bearing i created but i haven't testet it yet.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in