Thingiverse
Atto Quark Race canopy
by AttoFPV
7
Downloads
4
Likes
0
Makes
Race canopy for the Atto Quark quad.
Secures to the base plate by inserting the 3mm M3 standoffs included in the frame kit and fixing with 10mm M3 bolts.
Micro cameras will mount from 40-65°. A simple whip antenna should fit snugly through the hole on top and the fin will offer some protection as well as just lifting the rear props enough to turtle out of a crash on flat ground.
Print with higher infill for greater strength at the expense of weight. Mine is pretty bombproof at 50% in
Secures to the base plate by inserting the 3mm M3 standoffs included in the frame kit and fixing with 10mm M3 bolts.
Micro cameras will mount from 40-65°. A simple whip antenna should fit snugly through the hole on top and the fin will offer some protection as well as just lifting the rear props enough to turtle out of a crash on flat ground.
Print with higher infill for greater strength at the expense of weight. Mine is pretty bombproof at 50% in
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in