Thingiverse
DJI Mavic Pro drop device
by mclarin89
62
Downloads
43
Likes
0
Makes
Inspired by Isaiahsdad's drop rig https://www.thingiverse.com/thing:2898647.
This one attaches using 2 existing screws on the mavic. I replaced the screws with slightly longer ones. The screw thread is .078" (2mm) by 40tpi. Any pitch 2mm screw will probably work since it's going into plastic.
Printed 3shell 30% infill this comes out to 7.5g and is strong enough to hold a few ounces.
During testing it was a little too easy to drop the payload so I've made a V2 with the arms sloped upw
This one attaches using 2 existing screws on the mavic. I replaced the screws with slightly longer ones. The screw thread is .078" (2mm) by 40tpi. Any pitch 2mm screw will probably work since it's going into plastic.
Printed 3shell 30% infill this comes out to 7.5g and is strong enough to hold a few ounces.
During testing it was a little too easy to drop the payload so I've made a V2 with the arms sloped upw
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in