Thingiverse
Return to Castle Wolfenstein logo
by Ziddan
11
Downloads
23
Likes
0
Makes
In my make its sized for 1.5" belts, the buckle itself is just over 2" at the tallest point and 3.5" wide.
Found the logo in good resolution online, adapted the outline of a shield for the backing and frame using an image editor.
Converted the image to svg format and imported it to Tinkercad for proper sizing.
Printed it out on a diy i3 clone kit.
Bent and cut 4mm steel rod for the buckle hardware.
Cut slots in the back of the print to recess the hardware.
Molded it using o
Found the logo in good resolution online, adapted the outline of a shield for the backing and frame using an image editor.
Converted the image to svg format and imported it to Tinkercad for proper sizing.
Printed it out on a diy i3 clone kit.
Bent and cut 4mm steel rod for the buckle hardware.
Cut slots in the back of the print to recess the hardware.
Molded it using o
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in