Thingiverse
Anker USB HUB - 4x LED - Twist In 2020 Adapter - Ender, CR-10
by FedorSosnin
103
Downloads
59
Likes
2
Makes
This is a simple way to light up your print area that cost under 20 bucks that is non-permanent, has modular light output, and can be reused for other things when needed.
Print 2 of these adapters and twist into the top bar of your printer. Clip in the Anker (or simular) 4x USB HUB with your choice of 1 to 4 USB LEDs depending on how much light you need.
I used a USB extension cable from the hub right into my Raspberry Pi but you can use a buck/step-down converter and hardwire this right
Print 2 of these adapters and twist into the top bar of your printer. Clip in the Anker (or simular) 4x USB HUB with your choice of 1 to 4 USB LEDs depending on how much light you need.
I used a USB extension cable from the hub right into my Raspberry Pi but you can use a buck/step-down converter and hardwire this right
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in