Thingiverse
Step-on door stopper [my garage improvement]
by 3d-dragar
108
Downloads
89
Likes
0
Makes
Another one of my outdoor-tested designs which have defied the elements well. The door stopper is a piece of equipment that helps to hold the door open by using a tension spring. It works best on rough terrains but if you have a slick floor surface try to put rubber to the leg.
You need a 5 cm long spring or in my case 2x one-inch springs. I guess a rubber band will also do the trick, at least for a while. The spring's pivot is slightly off the centre, so it tends to go always into up or down
You need a 5 cm long spring or in my case 2x one-inch springs. I guess a rubber band will also do the trick, at least for a while. The spring's pivot is slightly off the centre, so it tends to go always into up or down
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in