Thingiverse
Wanhao i3 Plus X-axis/Z-axis rebuild
by martin_au
314
Downloads
143
Likes
4
Makes
This is a reworking of the Wanhao i3 Plus (Cocoon Create Touch) Z axis and X axis. This design came about because I had to check the X-axis idler pulley, which is very, very hard to access on an I3 plus!!!
Why should you install this?
1) This design makes maintenance on the X-axis much, much easier. Just unscrew 3 bolts on each side, and you can remove the entire X-axis gantry.
2) This design should improve print quality. The original design relies on grub screws to hold the X-axis rods
Why should you install this?
1) This design makes maintenance on the X-axis much, much easier. Just unscrew 3 bolts on each side, and you can remove the entire X-axis gantry.
2) This design should improve print quality. The original design relies on grub screws to hold the X-axis rods
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in