HighGreat Mark Tilting Camera Assembly

This is a set of 3D prints to enable the HighGreat Mark camera to be rotated. The drone needs to be modified as follows:-

1. Remove the 4 plastic patches under the motor arm swivel points (use a sharp knife to lever them up)
2. Unscrew the 4 central screws using a flathead screwdriver.
3. Remove the 2 screws hidden at the centre of the battry box using a torx screwdriver.
Lift off the top.
4. Undo the 2 cross head screws at the back of the pcb and then, carefully(!) slide it back an i