Thingiverse
Glass bed corner 4mm glass Slotted
by pynej
6
Downloads
2
Likes
0
Makes
This is a modified version that is shorter to accommodate 4mm glass without overhand, a slightly thicker bottom, recessed cutout to seat the washer, and a slot so the nut doesn't have to be removed to install.
Look at the back side to see what I mean about slotted. This is still rigged enough to not flex when heating the bed to 65c.
Print with 1.2mm wall, 20% infill and use the experimental Tree Support in cura.
The only minor issue is I don't have a good way to print the inset ring in
Look at the back side to see what I mean about slotted. This is still rigged enough to not flex when heating the bed to 65c.
Print with 1.2mm wall, 20% infill and use the experimental Tree Support in cura.
The only minor issue is I don't have a good way to print the inset ring in
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in