Thingiverse
Stackable rack
by jesse1990
54
Downloads
37
Likes
1
Makes
A stackable rack
Next to my television there is a modem, router and a few raspberry pi's. For these devices I have made a stackable rack. This allows these devices to stand on top of each other. There is a lot of room for draining hot air.
If you print more, they can be stacked. Print the rack upside down and use support for the 4 corners. Because the hot air can escape well, I went for PLA.
Next to my television there is a modem, router and a few raspberry pi's. For these devices I have made a stackable rack. This allows these devices to stand on top of each other. There is a lot of room for draining hot air.
If you print more, they can be stacked. Print the rack upside down and use support for the 4 corners. Because the hot air can escape well, I went for PLA.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in