Thingiverse
Honda SevenFifty Throttle Tube
by Elbeeyou
10
Downloads
10
Likes
0
Makes
I broke my throttle tube while trying to remove the cables...
And so I designed this part to teach myself to use Fusion 360 and then check if a printed part can replace the broken one.
After a first version printed with PLA, I wasn't confident about the robustness so I decided to try with ABS...
Well, as you should certainly know printing with ABS is more difficult, and of course, I had some trouble to get a good result. I studied a bit the purpose and modified my configuration :
* tempe
And so I designed this part to teach myself to use Fusion 360 and then check if a printed part can replace the broken one.
After a first version printed with PLA, I wasn't confident about the robustness so I decided to try with ABS...
Well, as you should certainly know printing with ABS is more difficult, and of course, I had some trouble to get a good result. I studied a bit the purpose and modified my configuration :
* tempe
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in