Thingiverse
Apex Qi Charger Phone Stand APX-6813
by MoshiBin
6
Downloads
7
Likes
0
Makes
Made a charging phone dock for my Apex Qi charger. This charger is quite a bit larger than other Qi chargers.
The dock has a tunnel for the micro-usb cable to go through.
Regarding infill: I printed the base at 8% to save time and material. I was worried that the arms will be fragile at 8%, so I changed them to 25%. Most slicers let you change slicing parameters at different heights - so up the infill at about 50mm height and upwards.
The dock has a tunnel for the micro-usb cable to go through.
Regarding infill: I printed the base at 8% to save time and material. I was worried that the arms will be fragile at 8%, so I changed them to 25%. Most slicers let you change slicing parameters at different heights - so up the infill at about 50mm height and upwards.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in