Thingiverse
Adafruit PowerBoost 500C Case
10
Downloads
7
Likes
0
Makes
Small case for the Adafruit PowerBoost 500C LiIon/LiPoly battery charger.
* https://www.adafruit.com/product/1944
The lid is press-fit with no latches; printer settings and accuracy will affect how well it stays on (e.g., if you need a rubber band, maybe tweak some settings--if it's a bit too tight, minor sanding should be sufficient). We just needed something to keep it off the desk.
The board just drops in over the posts at the USB connector end. There are two hold-down pins on the li
* https://www.adafruit.com/product/1944
The lid is press-fit with no latches; printer settings and accuracy will affect how well it stays on (e.g., if you need a rubber band, maybe tweak some settings--if it's a bit too tight, minor sanding should be sufficient). We just needed something to keep it off the desk.
The board just drops in over the posts at the USB connector end. There are two hold-down pins on the li
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in