Thingiverse
Dust Extractor for StepCraft HF500 Spindle
by NMNK
11
Downloads
4
Likes
0
Makes
I've just printed it and installed it and tested it once, so I will add some photos later on.
I printed and installed a initial version which used just 4 magnet to lock the brush, and it's not enough. The version I installed has tape holding the brush for now...
The uploaded model has 6 (it's the amount of magnet of the same kind I had). You can add more in the solidworks model in the circular pattern feature.
It was done fairly quickly without much planning for the 3D modeling itself,
I printed and installed a initial version which used just 4 magnet to lock the brush, and it's not enough. The version I installed has tape holding the brush for now...
The uploaded model has 6 (it's the amount of magnet of the same kind I had). You can add more in the solidworks model in the circular pattern feature.
It was done fairly quickly without much planning for the 3D modeling itself,
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in