Thingiverse
NodeMCU / Konnected Garage Box
by polandjon
36
Downloads
19
Likes
0
Makes
Houses a NodeMCU base board with CH340G chip in the bottom and a 2 channel relay in the top for use as a garage door controller using the konnected.io software. Learn more about the hardware and software at:
https://help.konnected.io/support/solutions/articles/32000022638-garage-door-hardware-setup
The NodeMCU board snaps into the bottom (put the power plug through the side first, then snap in other end). The relay is hot glued to the pegs in the top. The two parts simply slide together
https://help.konnected.io/support/solutions/articles/32000022638-garage-door-hardware-setup
The NodeMCU board snaps into the bottom (put the power plug through the side first, then snap in other end). The relay is hot glued to the pegs in the top. The two parts simply slide together
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in