Thingiverse
CR-X fan mount, wind guide, add-on mounting holes
by dinoding
25
Downloads
12
Likes
1
Makes
Another design of CR-X fan mount and wind guide integration.
In order for makers to add ABL or laser devices, etc. I designed two sets of mounting holes for more added function to happen.
The bigger hole is 7.2mm in each side, the smaller one is 2.8mm. The distance between center of two squares is 14.0mm (after you print it, you'll see the number 7.2, 2.8, 14.0 on upfront face of the mount). You should know these specs before you design your own add-on device shafts.
The bigger hole is des
In order for makers to add ABL or laser devices, etc. I designed two sets of mounting holes for more added function to happen.
The bigger hole is 7.2mm in each side, the smaller one is 2.8mm. The distance between center of two squares is 14.0mm (after you print it, you'll see the number 7.2, 2.8, 14.0 on upfront face of the mount). You should know these specs before you design your own add-on device shafts.
The bigger hole is des
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in