Thingiverse
EYE SET for "Seven the Articulated Dragon"
by Patstrick
174
Downloads
124
Likes
0
Makes
(THE SCREENSHOTS ARE NOT 100% ACCURATE. My dragon print is scaled to 125%. The middle bit of the spring is different to allow clearance for the string.)
Didn't like the eyes that needed to be glued in. This one not only makes them both one piece but adds a spring structure so you can snap them in. It also sets the proper 45deg angle so the eyes are looking forward.
Insert the eyes before the jaw and after you've run string through the neck. Be sure to be careful of the ball joints for the
Didn't like the eyes that needed to be glued in. This one not only makes them both one piece but adds a spring structure so you can snap them in. It also sets the proper 45deg angle so the eyes are looking forward.
Insert the eyes before the jaw and after you've run string through the neck. Be sure to be careful of the ball joints for the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in