Thingiverse
Monoprice Select Mini V2 Heat Bed Cable Tidy
15
Downloads
10
Likes
0
Makes
I routed the bed wiring through the back panel of the printer, so made a cable tidy for support and stabilisation.
A 10mm hole was drilled through the rear panel next to the board cooling fan and the rubber grommet refitted. I resleeved the bed wiring in braided sleeving and fed it through the grommet. The cable tidy was then clipped to this and secured to the sled by 2x M3 bolts with Nyloc nuts.
A 10mm hole was drilled through the rear panel next to the board cooling fan and the rubber grommet refitted. I resleeved the bed wiring in braided sleeving and fed it through the grommet. The cable tidy was then clipped to this and secured to the sled by 2x M3 bolts with Nyloc nuts.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in