Thingiverse
32 Channel Servo Controller Enclosure
door MclovinST
2
Downloads
0
Likes
0
Makes
I needed an easy to use enclosure for my 32 Channel Servo driver for a robotic arm project that i want to work on.
The board is a friction fit onto the printed dowels on the bottom of the casing. USB port in the side of the enclosure is big enough to accommodate the USB cable easily. servo plugs fit through the lid without any issues and theres a centre hole in the lid for access to the reset button.
The lid is just a friction fit which clips in quite nice and snug.
Designed in Fusion 360
Printing:
Print the two components flat sides down
0.4mm Nozzle
0.25mm Layer Height
5% infill
1mm Wall Thickness.
The board is a friction fit onto the printed dowels on the bottom of the casing. USB port in the side of the enclosure is big enough to accommodate the USB cable easily. servo plugs fit through the lid without any issues and theres a centre hole in the lid for access to the reset button.
The lid is just a friction fit which clips in quite nice and snug.
Designed in Fusion 360
Printing:
Print the two components flat sides down
0.4mm Nozzle
0.25mm Layer Height
5% infill
1mm Wall Thickness.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
