Thingiverse

Prusa MK3/MK3s Rubber Feet Support/Stabiliser

by wardy89

258 Downloads

145 Likes

5 Makes

Download Model

feet i3 mk3s mk3 mk3s original prusa mk3s prusa prusa i3 prusa i3 mk3 prusa i3 mk3s prusa mk3 Prusa mk3s stabilizer support feet i3 mk3s mk3 mk3s original prusa mk3s prusa prusa i3 prusa i3 mk3 prusa i3 mk3s prusa mk3 Prusa mk3s stabilizer support

So the stock rubber feet for the MK3 leaves your printer wobbling all over the place, the hard feet are great but make your printer a lot noisier. There has to be a better solution right?

This is a designed to hold the stock rubber feet in place while stabilising them as much as possible. I have achieved this by designing the foot holder so that only a very small proportion of the foot clears the bottom of the support. The other part to this is that the foot holder is slightly undersized so

Source

Thingiverse

Comments

Makes