Thingiverse
Mount for PLV Z4 Video Projector
by dolomitt
1
Downloads
0
Likes
0
Makes
I needed a way to attach my video projector in my house on an existing structure. The upper part fits the mount attachments, the lower part fits an existing support in U shape.
Pretty tight on the screw side.
Printed in PLA 1.75mm at 205 degrees celsius on a Creality CR10S. Took a bit less than 48 hours, at 20% infill, for a result of ~650g or so.
A small brim around, was kind of tough to remove from the plate.
Pretty tight on the screw side.
Printed in PLA 1.75mm at 205 degrees celsius on a Creality CR10S. Took a bit less than 48 hours, at 20% infill, for a result of ~650g or so.
A small brim around, was kind of tough to remove from the plate.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in