Cable Wrap Mould & Tips

Printed this using the following settings:

Infil: 50%
Supports: Off
Raft: On
Shells: 2
Layer Height: 0.10 mm

Used 20 guage wire and oogoo.

1) Put one of the tips onto the wire and make a hook at the end of the wire.
2) Tuck the wire hook into the tip.
3) Cut the wire slightly longer then the mould.
4) Mix up a 1/2 teaspoon each of cornstarch and silicone, add a few drops of food coloring if you like (= Oogoo).
5) Spread the Oogoo into the mould halves and add the wire a