Thingiverse
Stone Age Game Chieftain/First Player Stand
by Nerdator
16
Downloads
10
Likes
0
Makes
The original cross feet for the chieftain/first player figure I got in my Stone Age box were way too loose (with the cut-outs about half a millimetre too wide, actually), and fell out as soon as you lifted the figure.
This was the right job for the 3D Printer Man, and here we have a really snug-fitting (1.8 mm wide gap between the vertical bits. The rib inside them is 2 mm wide) stand that doesn't fall off.
It's quite strong and will withstand transport in the box, and it won't tip over un
This was the right job for the 3D Printer Man, and here we have a really snug-fitting (1.8 mm wide gap between the vertical bits. The rib inside them is 2 mm wide) stand that doesn't fall off.
It's quite strong and will withstand transport in the box, and it won't tip over un
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in