Thingiverse
fan cooled 3.5 TFT Raspberry Pi 3 B/B+ Case (Remixed)
by moohman
24
Downloads
11
Likes
0
Makes
Once I bought a Raspberry Pi 3 Display and printed a sleeve for it, I noticed it overheating at times.
But the Sleeve I printed was too small to add a cooler to it.
I found this design but it was incomplete.
I just streched the top to match the Raspberry Pi3 and it's display and cut a hole inside it.
Known issues: the top part may or may not fit with your display. I assume as my print was warped a bit, I had to use a lighter to soften the case to get the display in there.
Fan used: 30mm
But the Sleeve I printed was too small to add a cooler to it.
I found this design but it was incomplete.
I just streched the top to match the Raspberry Pi3 and it's display and cut a hole inside it.
Known issues: the top part may or may not fit with your display. I assume as my print was warped a bit, I had to use a lighter to soften the case to get the display in there.
Fan used: 30mm
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in