Thingiverse
Raspberry Pi 3 B+ case for Prusa MK3/S/+ (30 mm fan version)
by binyae
30
Downloads
16
Likes
0
Makes
Raspberry Pi 3 B+ case for Prusa MK3/S/+ (OctoPrint / OctoPi setup) - 30 mm fan version.
Screws needed (cap head hexagon socket drive screws):
3 x M3x8
8 x M3x12 and 4 nuts
**Using M3 screws IS POSSIBLE with the RPI board. I recommend running the screws through the holes of the board GENTLY once before assembly.
I used the 30 mm iUniker Pi fan (bought on Amazon.com) for this version.
No support needed!
**For fanless version go to: https://www.thingiverse.com/thing:3199058.
Screws needed (cap head hexagon socket drive screws):
3 x M3x8
8 x M3x12 and 4 nuts
**Using M3 screws IS POSSIBLE with the RPI board. I recommend running the screws through the holes of the board GENTLY once before assembly.
I used the 30 mm iUniker Pi fan (bought on Amazon.com) for this version.
No support needed!
**For fanless version go to: https://www.thingiverse.com/thing:3199058.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in