Thingiverse
Vortex Cooler Mk IV
by tibmeister
7
Downloads
9
Likes
0
Makes
This is my design of a new part cooling nozzle for my Monoprice Maker Select v2. This is the Mk IV, Mk I, II, and III where the prototypes and were very ugly to say the least. A lot of learning came from those to make the Mk IV a reality.
The Mk IV is designed based on the inversion of an airplane wing to create a low-pressure zone on the inside of the circle, near the nozzle. This will draw in cooler air from above the nozzle and combine it with the air coming out of the cooler from the
The Mk IV is designed based on the inversion of an airplane wing to create a low-pressure zone on the inside of the circle, near the nozzle. This will draw in cooler air from above the nozzle and combine it with the air coming out of the cooler from the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in