Thingiverse
XBox adaptive controller low cost/force buttons
by Davross
48
Downloads
44
Likes
3
Makes
I'm was not prepared to pay $60 plus for a simple push-button to connect to my Xbox adaptive controller so I designed my own...
These can be made as a single button, or a gang of two. They require one mono 3.5 mm jack per switch (I buy a double ended extension and cut in half) and a low cost switch.
I use a piece of cut 3 mm carbon rod as the axle, but an M3 bolt would work just as well.
EBay links to these items below:
https://www.ebay.co.uk/itm/Tactile-Switch-PCB-Tact-Push-Button-M
These can be made as a single button, or a gang of two. They require one mono 3.5 mm jack per switch (I buy a double ended extension and cut in half) and a low cost switch.
I use a piece of cut 3 mm carbon rod as the axle, but an M3 bolt would work just as well.
EBay links to these items below:
https://www.ebay.co.uk/itm/Tactile-Switch-PCB-Tact-Push-Button-M
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in