Thingiverse
Twist N' Clip (2020 Extrusion Cable Clip)
by PKVTX
35
Downloads
26
Likes
0
Makes
I needed a cable clip for my CR-10s and decided to design my own to fit into a 2020 extrusion.
To clip it onto the extrusion place it in the channel then, twist it 90 degrees clockwise. The first time clipping it on, it might be tight but that's normal.
The 3mm cable clip will fit a sleeved stepper cable.
The 5mm clip will fit a stepper cable and 2 pin sensor cable sleeved together.
Other size clips may be made in the future. If you decide to make this please post a comment or picture
To clip it onto the extrusion place it in the channel then, twist it 90 degrees clockwise. The first time clipping it on, it might be tight but that's normal.
The 3mm cable clip will fit a sleeved stepper cable.
The 5mm clip will fit a stepper cable and 2 pin sensor cable sleeved together.
Other size clips may be made in the future. If you decide to make this please post a comment or picture
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in