Thingiverse
Mellowboard Cruiser Tailguard
by gonstr
3
Downloads
2
Likes
0
Makes
Rear tailguard for the [mellowboard cruiser](https://www.mellowboards.com).
The guard attaches to the back of the board and is held in place with the rear two screws of the mellow drive.
Protects the back of the board from scratches when leaning it towards the ground or picking it up and putting it down.
I recommend printing this in PETG because its durability and resistance to cracking/breaking. I used 5 perimeter layers and 20% infill but you can also print in using 100% infill.
Ed
The guard attaches to the back of the board and is held in place with the rear two screws of the mellow drive.
Protects the back of the board from scratches when leaning it towards the ground or picking it up and putting it down.
I recommend printing this in PETG because its durability and resistance to cracking/breaking. I used 5 perimeter layers and 20% infill but you can also print in using 100% infill.
Ed
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in