Thingiverse
Filament Clamp Holder 1.75mm
by 8orge
67
Downloads
61
Likes
0
Makes
This is a little holder for your 1.75mm filament ,so the filament do not get tangled up .
If you found this design very helpful or otherwise wish to support me ,you can buy me a cup of coffee ( helps keeping the brain active so i can create new stuff ) ;-) ,then please
consider using this link :
I have designed this holder with a larger hole in the one end and a
smaller one in the other end "the arrows indicate from which end you have to
push the end-tip through " ,this ensures t
If you found this design very helpful or otherwise wish to support me ,you can buy me a cup of coffee ( helps keeping the brain active so i can create new stuff ) ;-) ,then please
consider using this link :
I have designed this holder with a larger hole in the one end and a
smaller one in the other end "the arrows indicate from which end you have to
push the end-tip through " ,this ensures t
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in