Anycubic Chiron Light System

This is my new design to add a light on the X-Axis of the Anycubic Chiron 3D printer.

To make this you require the following materials:

-PLA/ABS/PETG for the support that holds the LED Strip (Black it's suggested)
-PLA/PETG TRANSPARENT COLOR (Transparent neutral is better) for the Light diffusor
-LED Strip 35cm lenght
-3 screws M4
-3 T-nuts
-2 couple of 2 wires connectors
-about 60cm of wires red/black AWG26 or similar type (black is better)


If you use a 24V volt you are ok. If