Thingiverse
Improved fan duct for Creality CR-10
by MrMRo
20
Downloads
21
Likes
1
Makes
Improved fan duct and part cooling fan mount for the Creality CR-10.
This design should work with the stock fans and screws, no additional hardware needed and no modifications to the cabling. There is no need to move or even touch the hot end, it can stay in it's original position.
I was having trouble with failed prints due to clogging in the hotend caused by poor cooling. The design of the stock fan duct is far from optimal but works well with the powerful stock fan, not so much with a N
This design should work with the stock fans and screws, no additional hardware needed and no modifications to the cabling. There is no need to move or even touch the hot end, it can stay in it's original position.
I was having trouble with failed prints due to clogging in the hotend caused by poor cooling. The design of the stock fan duct is far from optimal but works well with the powerful stock fan, not so much with a N
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in