Thingiverse
Calibration Gallows for 3D printers (torture test)
22
Downloads
9
Likes
1
Makes
This is an extreme test for calibrating your 3D printer. STEP and STL provided.
Print flat side down.
V3 files are extremely punishing and most if not all FDM printers will fail on the more tricky areas.
V4 files are a bit easier to print but most if not all FDM printers will fail on the more tricky areas still. This at least gives the printers a fighting chance on the thin wall section.
100x100x50 for calibration of stepper drivers
square shape cailbration 20 - 1mm
circle shape
Print flat side down.
V3 files are extremely punishing and most if not all FDM printers will fail on the more tricky areas.
V4 files are a bit easier to print but most if not all FDM printers will fail on the more tricky areas still. This at least gives the printers a fighting chance on the thin wall section.
100x100x50 for calibration of stepper drivers
square shape cailbration 20 - 1mm
circle shape
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in