Thingiverse
HICTOP 3DP-17 ATHORBOT A01 i3 Z Axis Leveller
by JulesLobo
6
Downloads
5
Likes
0
Makes
Hej fellow Makers!
This is my design of yet another z-axis leveller for a HICTOP 3DP-11/13/17 / ATHORBOT A01 Prusa i3-clone (it's identical) built with a single 20x20 ITEM frame.
Just print two pieces, put them between frame and z-rods and screw the leadscrews to the upper surface of the levellers. The bottom side without the smaller wall goes over the rear motor bracket screw towards the z frame.
Enjoy!
If you have an improvement proposal please leave a comment.
Unfortunately nec
This is my design of yet another z-axis leveller for a HICTOP 3DP-11/13/17 / ATHORBOT A01 Prusa i3-clone (it's identical) built with a single 20x20 ITEM frame.
Just print two pieces, put them between frame and z-rods and screw the leadscrews to the upper surface of the levellers. The bottom side without the smaller wall goes over the rear motor bracket screw towards the z frame.
Enjoy!
If you have an improvement proposal please leave a comment.
Unfortunately nec
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in