Thingiverse
Raspberry Pi 3A+ with Pi1541 IO Hat Case
by Tom_DD
68
Downloads
39
Likes
1
Makes
Raspberry Pi 3A+ with Pi1541 IO hat case giving full access to the main outputs of the IO hat, including the two 6pin DINs, the 5 side buttons, the 2 leds & the OLED connector. Also has a commodore logo over the GPIO buzzer so it is not covered up and a larger logo on the bottom doubling as an air vent.
Print top and bottom sections and 2 x stands for the hat
Secured with 7.5mm M3 pan head screws (black)
*Small revision moving the reset switch hole 0.5mm so it's a better fit
**Added
Print top and bottom sections and 2 x stands for the hat
Secured with 7.5mm M3 pan head screws (black)
*Small revision moving the reset switch hole 0.5mm so it's a better fit
**Added
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in