Thingiverse
helloBEEprusa Single X carriage E3d V6 Bowden
by Doomingos
10
Downloads
8
Likes
0
Makes
A custom carriage for the helloBEEprusa that allows mounting one E3D V6, while reusing the original cooling duct, and maintaining the original aesthetic.
Also lowers the carriage weight significantly as there are no bearing holders required, only zipties, and only one extruder
Required material:
- Original helloBEEprusa screws and cooling duct
- some 4mm width zipties to hold the bearings in place.
- M3 tapping drill
- 5 x M3x30
- 3x M3 nut, nylok if available
Recommended print set
Also lowers the carriage weight significantly as there are no bearing holders required, only zipties, and only one extruder
Required material:
- Original helloBEEprusa screws and cooling duct
- some 4mm width zipties to hold the bearings in place.
- M3 tapping drill
- 5 x M3x30
- 3x M3 nut, nylok if available
Recommended print set
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in