Thingiverse
2 channel non usb eletronic relay case
by Mago3d
21
Downloads
10
Likes
0
Makes
Found this neat case for a double relay, just my relay was not an USB one, but one that would be controlled via the raspberry PI GPIO connectors using Dupont cables.
My remix consisted in:
1-Close the opening for the USB connector
2-Open a slot for the Dupont wires to come in and connect to the relay
3-Bring the holes where to screw the relay board closer together.
12/17/2018
-Added another lower case for a different model of relay switch.
-Renamed the lower case file names to now
My remix consisted in:
1-Close the opening for the USB connector
2-Open a slot for the Dupont wires to come in and connect to the relay
3-Bring the holes where to screw the relay board closer together.
12/17/2018
-Added another lower case for a different model of relay switch.
-Renamed the lower case file names to now
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in