Thingiverse
Pliers holder
by fthouret
7
Downloads
2
Likes
0
Makes
The actual .slt is a bit modified compared to the pictures :
- the screw head hole is a bit larger (6.5mm vs 6mm on the picture).
- the fillets around the holder itself are a bit bigger (0.7mm vs 0.5mm on the pictures).
Juste rotate it 90 degrees, as it will set. And add supports.
- the screw head hole is a bit larger (6.5mm vs 6mm on the picture).
- the fillets around the holder itself are a bit bigger (0.7mm vs 0.5mm on the pictures).
Juste rotate it 90 degrees, as it will set. And add supports.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in