Thingiverse
WiModem Case Beefy Edition
by ssshake
4
Downloads
2
Likes
1
Makes
I wanted a case that was a bit more beefy, thick. Cartridgy if you will.
Protip: to fill the hole for the LED so that it looks better, simple put a piece of scotch tape over the outside of it, then fill the hole with clear hot glue. Wait for the glue to cool, remove tape and you have a nice, consistent, diffused light.
The heat from the glue will make the PLA malleable so dont touch anything while it's cooling. Optionally take a can of compressed air, turn it up side down and zap the area
Protip: to fill the hole for the LED so that it looks better, simple put a piece of scotch tape over the outside of it, then fill the hole with clear hot glue. Wait for the glue to cool, remove tape and you have a nice, consistent, diffused light.
The heat from the glue will make the PLA malleable so dont touch anything while it's cooling. Optionally take a can of compressed air, turn it up side down and zap the area
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in