Thingiverse
Icicle Ornament for vase mode
by DustyDingus
33
Downloads
15
Likes
1
Makes
My mother wanted icicle ornaments but couldn't find ones she wanted. I printed a set of these in white and a set in clear high temp PLA. She hung a mix of both on her tree and loved it.
Print in vase mode except for the hook. The hook should just snap in, if not try scaling it a bit.
Update:
It was so long ago when I actually printed these that I forgot I also scaled the icicle in Cura to be longer and skinnier and thus much more icicle like than the original. I think 15ish mm in X/Y and to
Print in vase mode except for the hook. The hook should just snap in, if not try scaling it a bit.
Update:
It was so long ago when I actually printed these that I forgot I also scaled the icicle in Cura to be longer and skinnier and thus much more icicle like than the original. I think 15ish mm in X/Y and to
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in