Thingiverse
Commodore 64 Joystick
by senseimakes
54
Downloads
40
Likes
0
Makes
Not a fan of most C64 joysticks so decided to make my own using an old donor joystick.
Printed using PLA at 10% infill on all prints.
Top STL:
I didn't add the shaft holes as those can differ depending on the type of joystick you get.
The buttons have 28mm shafts which can easily be found on eBay or places like https://www.arcadeworlduk.com/
Wall STL:
The side supports can be glued if you wish but I find just using the two recessed screw holes are plenty to keep the wall and top tigh
Printed using PLA at 10% infill on all prints.
Top STL:
I didn't add the shaft holes as those can differ depending on the type of joystick you get.
The buttons have 28mm shafts which can easily be found on eBay or places like https://www.arcadeworlduk.com/
Wall STL:
The side supports can be glued if you wish but I find just using the two recessed screw holes are plenty to keep the wall and top tigh
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in