Thingiverse
Aquarium Decoration - Textured Rock Cave - Medium
327
Downloads
252
Likes
2
Makes
Custom Rock shaped cave with two entries for fish, shrimp or reptiles. 20cm X 12cm X 7cm.
Designed with 2mm walls and meant to be printed with 100% infill and no supports; thin walls in design make it unsuitable for significant re-sizing.
This model may have a bit of filament sag due to the somewhat flat roof, but it will print successfully without supports.
PLA and PETG are both denser than freshwater so 100% infill will naturally sink to the bottom of the tank.
On safety and longev
Designed with 2mm walls and meant to be printed with 100% infill and no supports; thin walls in design make it unsuitable for significant re-sizing.
This model may have a bit of filament sag due to the somewhat flat roof, but it will print successfully without supports.
PLA and PETG are both denser than freshwater so 100% infill will naturally sink to the bottom of the tank.
On safety and longev
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in