Thingiverse
Generic Impeller with Casing
by Supremmacy
16
Downloads
12
Likes
0
Makes
Generic 8 spline Impeller with a custom made case. Was a term project that I designed for school.
Designed to be attached to a DC motor at the centre with a 38mm(diameter) x 120mm spindle (not in the thingiverse files). When turned on with an Arduino controller, use the micro controller to adjust RPM to draw a vacuum which can be used for a variety of things!
Here's some measurements for reference
278mm x 230mm x 92mm (size of casing)
183mm x 183mm x 51mm (size of impeller)
Attached a
Designed to be attached to a DC motor at the centre with a 38mm(diameter) x 120mm spindle (not in the thingiverse files). When turned on with an Arduino controller, use the micro controller to adjust RPM to draw a vacuum which can be used for a variety of things!
Here's some measurements for reference
278mm x 230mm x 92mm (size of casing)
183mm x 183mm x 51mm (size of impeller)
Attached a
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in