Thingiverse
Winterdecoration
by Labadorium
93
Downloads
72
Likes
0
Makes
Careful, it is pointy as the original.
(The sensation felt when overcome a certain pressure point is almost identical painful)
This is an easy print.
No supports needed.
I printed this with a .25 nozzle and a layer height of .150
Around 3,5 hrs and roughly 16gram.
Cooling increasingly to the top would be good.
I printed it this way, not sure if it was needed though.
In between the "branches" are small balls for decoration.
Just accept the challenge to paint them :)
/////
(The sensation felt when overcome a certain pressure point is almost identical painful)
This is an easy print.
No supports needed.
I printed this with a .25 nozzle and a layer height of .150
Around 3,5 hrs and roughly 16gram.
Cooling increasingly to the top would be good.
I printed it this way, not sure if it was needed though.
In between the "branches" are small balls for decoration.
Just accept the challenge to paint them :)
/////
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in